Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the truck arrives.
Get your free estimateStyles & brands we work with
See the difference
Before
After
Before
After
Before
AfterSpring Repair in Pasadena, CA
Garage door spring repair in Pasadena typically runs $180 to $340 for a single torsion spring replacement, and $280 to $550 when both springs need to go. Most spring failures can be repaired the same day, and a broken spring should be addressed immediately because the door’s full weight sits on that one component. If your garage door won’t open and you hear a loud bang from the garage, that’s almost always a spring letting go. Call Brock Garage Doors Pasadena at (626) 788-0967 and a real person will answer, day or night.
Springs are the muscle behind your garage door. A torsion spring, the thick coiled spring mounted above the door opening, bears most of the lifting load every single time the door moves. When it snaps, the door becomes dead weight, and no amount of opener force will lift it properly. That’s where our Garage Door Repair team steps in. We replace springs on every major brand, and we do it with the price in writing before the first bolt comes off.
Wade Mercer runs this shop, and the standard here is simple: show up in the window we give you, hand over a written price, do the job by the book, leave the site clean, and stand behind the work for a full year. No verbal estimates. No price that changes at the door. No callbacks that turn into arguments. That’s The Garrison Standard, and every technician on our Pasadena crew works to it.
When You Need Spring Repair
Springs don’t fail quietly, and they don’t fail halfway. Here’s what we hear from Pasadena homeowners when they call, and what each symptom actually means:
- A loud bang from the garage, like a firecracker or a car backfiring. That’s the spring snapping under tension. One or both springs may have just failed, and the door will not open correctly until they’re replaced.
- The door opens a few inches, then stops or slams back down. A broken spring means the opener is fighting the full, unbalanced weight of the door. Forcing it causes damage to the opener motor, cables, and tracks.
- The door feels impossibly heavy when you try to lift it manually. A healthy door with working springs should lift with one hand. When a spring breaks, that door weighs 150 to 250 pounds of dead metal.
- Visible gap in the torsion spring above the door. Look up; if you see a two-inch separation in the coil, the spring has snapped clean through. That’s the failure point, and it needs a full replacement, not a patch.
- The door is crooked or one side hangs lower than the other. A snapped spring on one side throws the load off balance. Cables can slip off the drums, and the door can bind in the tracks.
- The opener runs but the door barely moves. In Pasadena’s older homes, we see this a lot on original LiftMaster and Genie openers paired with springs that have reached the end of their cycle life. The opener isn’t built to carry the door by itself.
Springs are rated for a certain number of cycles, usually 10,000 to 20,000 open-and-close operations. That sounds like a lot until you do the math. A household that cycles the door four times a day hits 10,000 cycles in about seven years. If your Pasadena home has a door from the mid-2010s that has never had spring work, you’re in the replacement window right now.
Our Spring Repair Process
Here’s exactly how a spring repair goes when you call Brock Garage Doors Pasadena:
- Call and talk to a live person. There’s no voicemail tree. You call (626) 788-0967, a person answers, and we schedule a window that works for you. Nights, weekends, holidays, same day when we have a truck available.
- We show up in the window we gave you. Every technician is background-checked, uniformed, and drives a marked truck. You’ll know who’s at your door before you open it.
- We inspect the full system, not just the broken spring. A snapped spring puts stress on cables, drums, hinges, and the opener itself. We check all of it, because replacing a spring without checking the rest leaves you with a second failure waiting to happen.
- You get a written price before any work starts. We hand you the number. It covers the spring, the labor, and the hardware. If the number changes, you approve it before we turn a single bolt. That’s how it works here.
- We replace the spring or springs with the correct part for your door. We keep stock for Chamberlain, LiftMaster, Genie, and Raynor doors, and we match the spring to the door’s weight, height, and cycle rating. Not a universal part, the right part.
- We test the door, balance it, and clean up. The site looks like we were never there except for a smooth, balanced door. Every job carries a written 365-day guarantee: if the covered repair fails within a year, we return and correct it at no charge.
Spring Repair Pricing in Pasadena
Let’s talk real numbers. You should know how much garage door repair costs before you pick up the phone.
| Service | Typical Cost in Pasadena |
|---|---|
| Single torsion spring replacement | $180 – $340 |
| Double torsion spring replacement (both sides) | $280 – $550 |
| Extension spring replacement (older doors) | $150 – $250 |
| Spring plus cable replacement | $220 – $400 |
| Safety cable installation (extension spring systems) | $80 – $150 per door |
What moves the price? Door weight and height matter most. A single-car door needs lighter springs than a heavy wooden two-car door. Spring cycle rating moves the number too: a 20,000-cycle spring costs more than a 10,000-cycle spring, and we’ll show you both options so you can decide. Older Pasadena bungalows with original extension spring setups sometimes need a conversion to torsion, which adds hardware cost but gives you a safer, longer-lasting system.
We recommend replacing both springs when one fails. Here’s why: the two springs wear at nearly the same rate. If one snapped, the other is usually weeks or months behind it. You’ll pay for a second service call if you only replace the broken one, and most Pasadena homeowners would rather do it once and be done. We’ll show you the single-spring price and the pair price, and you decide. Estimates are free, and the written quote is yours to keep whether or not we do the work.
FAQs – Spring Repair
How much does garage door spring repair cost in Pasadena?
Spring repair in Pasadena typically runs $180 to $340 for one torsion spring and $280 to $550 for a pair. Extension springs run lower, around $150 to $250. Your exact number depends on door weight, spring cycle rating, and whether cable repair or other parts are involved. Call (626) 788-0967 for a free written estimate with the exact price before any work starts.
Can you repair a garage door spring the same day?
Yes, in most cases. We stock springs for the common Chamberlain, LiftMaster, Genie, and Raynor systems and run trucks across Pasadena all day. If you call before early afternoon, we can usually get a technician to your home the same day. A live person answers 24/7 at (626) 788-0967, so you can check same-day availability any time.
Is it cheaper to repair or replace a garage door spring?
Repair is almost always cheaper than replacing the entire door. A spring replacement costs a few hundred dollars, while a new door runs $1,200 to $3,500 installed. If your Pasadena door is structurally sound and the panels and tracks are properly aligned, replacing the springs is the financially sensible move. We’ll tell you honestly if your door isn’t worth repairing, and we’ll show you the numbers for both paths so you can decide without pressure.
Why should I replace both springs when only one is broken?
Both springs wear at nearly the same rate because they cycle together every time the door moves. If one snapped, the other is close behind. Replacing both now costs less than paying for two separate service calls, and it means your door won’t fail again in a few weeks. We’ll give you both quotes in writing. You choose. Call (626) 788-0967 and we’ll walk you through it.
Is a broken garage door spring dangerous?
Yes. A torsion spring stores an enormous amount of mechanical energy, and even a broken one can still be under residual tension. Do not attempt to remove, adjust, or replace a garage door spring yourself. This is a job for a trained professional with the right winding bars, safety procedures, and experience. Our technicians handle spring work daily, and they do it with the proper equipment and full attention to safety.
Why Pasadena Homeowners Call Brock
We’re an independently owned and operated shop, part of the Garrison Partners network since 2001. That means local decision-making with national accountability. Wade Mercer answers for every job that leaves our shop, and every repair carries The Garrison Standard: a written price before work starts, a clean work site, and a written 365-day guarantee. If a covered repair fails within that year, we return and make it right at no charge. That’s not a marketing line; it’s how we run every single job.
Our technicians are trained on eight major brands, including home page visitors’ most common systems: LiftMaster, Chamberlain, Genie, and Raynor. We match the spring to the door spec, not to whatever is on the truck. That’s the difference between a repair that lasts seven years and one that fails again in seven months.
If your garage door spring snapped in Pasadena, don’t force the door open and don’t try to fix it yourself. Call (626) 788-0967. A real person answers. We’ll give you a straight answer, a straight price, and a repair done right.
Written by Wade Mercer, Owner at Brock Garage Doors Pasadena, serving Pasadena.